Radium Nissan Injector Seat Kit, 30Mm, 6 Cylinder Radium Fitting 8An Orb To M12X1.5 Female and E85 Compliant

and E85 Compliant

This Improved ‘working ratio’ is achieved through an increase to the effective surface area of the diaphragm & revisions to the actual springs fitted

CAN Bus Position Demand Target

8AN ORB to 10AN Male

This system requires a single aftermarket fuel pump (sold separately)

Radium Nissan Injector Seat Kit, 30Mm, 6 Cylinder Radium Fitting 8An Orb To M12X1.5 Female and E85 CompliantThese are the same machined aluminum injector seats used in Radium fuel rail kits. They are required when converting an OEM side feed injector to a top feed injector that uses a 14mm lower O ring. They simply "pop" into the intake manifold (1 required per injector). They seal to the machined injector counterbore using the included FKM O ring. The 2 sizes are based on the intake manifold's inside diameter of each injector counterbore. Below are just a